I'm posting this on Handbrake's support forum (Didn't know there was one when I posted, sorry)
Ok, I ripped my DVD library to full ISO's using DVD Decrypter and had success 95% of the time. I installed AnyDVD and for some reason it seemed to work on the failed DVD's after that. So, all my DVD's are now in ISO format and seem to work fine.
So, I want to try converting to h.264 to get an idea of what I'm in for in the near future with regards to a big encoding project.
I open handbrake and use the default settings, choose the source (an ISO mounted with SlySoft Virtual CD Drive), and start the encoding to a destination that is not the same as that where the ISO lies. I'm getting about 450 FPS conversion and then it crashes at about 9%. I've tried a number of discs, all mounted the same way and the same result.
Can I just load an ISO without mounting it? Would that help? Why is Handbrake crashing?
I've tried 120 second previews and it works fine there.
What's going on here?
Thanks in advance for any suggestions, this is driving me nuts!
Ok, I ripped my DVD library to full ISO's using DVD Decrypter and had success 95% of the time. I installed AnyDVD and for some reason it seemed to work on the failed DVD's after that. So, all my DVD's are now in ISO format and seem to work fine.
So, I want to try converting to h.264 to get an idea of what I'm in for in the near future with regards to a big encoding project.
I open handbrake and use the default settings, choose the source (an ISO mounted with SlySoft Virtual CD Drive), and start the encoding to a destination that is not the same as that where the ISO lies. I'm getting about 450 FPS conversion and then it crashes at about 9%. I've tried a number of discs, all mounted the same way and the same result.
Can I just load an ISO without mounting it? Would that help? Why is Handbrake crashing?
I've tried 120 second previews and it works fine there.
What's going on here?
Thanks in advance for any suggestions, this is driving me nuts!